Editing A Sample (Hardware) - Native Instruments MASCHINE MIKRO MK2 Manual

[YYMMDD]_[HHMMSS].wav
In the name above, [YYMMDD] stands for the current date (year, month, day, all 2-digit num-
bers) and [HHMMSS] for the current time (hours, minutes, seconds, all 2-digit numbers).
11.1.2

Editing a Sample (Hardware)

Press Button 2 to access the
of the Sample and create a loop. The right display shows you the waveform of the Sample. Use
Knob 5 to zoom in on the waveform of the Sample and Knob 6 to navigate through it.
If your Sound contains more than one Sample, all your actions in the
the Sample of the Zone currently selected in the
(Hardware) for more info on selecting Zones in the
The Sample can be played back at any time by pressing the corresponding pad on your control-
ler. When the Sample is played back, the Playhead indicator (vertical line) shows you the cur-
rent play position within the waveform on the right display.
The parameters available on the left display are spread over three pages. Use the Page buttons
on the left of the displays to select the desired page.
Page 1 – Trim Parameters
The EDIT page on the controller, page 1 of 3: adjusting the start and end point of the Sample.
Parameter
START
END
Hold SHIFT when turning the Knobs to adjust the parameters in finer increments.
EDIT page. Here you can for example edit the start and end point
Description
Using Knob 1 you can adjust the start point of the Sample.
Using Knob 2 you can adjust the end point of the Sample.
Controlling Sampling from the Hardware
EDIT
MAP page! See ↑11.1.3, Slicing a Sample
MAP page.
MASCHINE MIKRO MK2 - Manual - 282
Sampling and Sample Mapping
page will affect