Native Instruments MASCHINE MIKRO MK2 Manual page 275

◦ If Retrigger is disabled (default
the current position in the previously selected Scene: e.g., leaving the current Scene
on beat 3 will cause the new Scene to start playing on its beat 3. This ensures that
the global groove of your track is not interrupted!
Hardware
To adjust the Scene Sync setting:
1. Press and hold GRID
2. Press Button 2 to select SYNC.
On the right display you see the available Scene Sync values. The current value is high-
lighted and the corresponding pad is lit. The default value
the next time you select a new Scene or loop range, the switch will happen once the cur-
rent Scene has played to the end.
3. Press a pad to select the desired value, for example pad
The next time you select a new Scene or loop range, the switch will happen on the next
→
quarter note.
To adjust the Retrigger setting:
1. Press and hold SCENE
At the bottom left corner of the left display you see the current Retrigger value
default).
2. Turn Knob 1 to select the desired value, for example ON.
The next time you select a new Scene or loop range, it will start from the beginning.
→
setting),
to enter Grid mode (or pin it by pressing
to enter Scene mode (or pin it by pressing
the next loop range you choose will start at
GRID + Button 1).
SCENE
3 (for 1/4, a quarter note).
SCENE
MASCHINE MIKRO MK2 - Manual - 275
Creating a Song using Scenes
Playing with Scenes
(pad 15) means that
+ Button 1).
(OFF by