Table of Contents
Advertisement
9.4.2
Routing Audio to a Send Effect
Once you have configured a Sound as send effect (see
Effect
above), you can send the output of any other Sounds and Groups to that Sound. For this
purpose, each Sound/Group is equipped with an additional two auxiliary outputs available in its
Output Properties.
Hardware
1.
Press the
CONTROL
2.
If you want to route a Group's output to the send effect, press Button 2 to select the
GROUP
tab and press the Group button
3.
If you want to route a Sound's output to the send effect, press Button 3 to select the
SOUND
tab, press the Group button
SELECT
+ the pad of that Sound (or simply press its pad if pads are in Group mode).
4.
Make sure
MODULES
5.
Press Button 8 (OUT) to display the Output Properties.
The Output Properties are shown in the displays of your controller (in the example under-
neath we show the Output Properties of a Group).
6.
Turn Knob 5
(AUX 1
auxiliary output to the desired send effect. In addition to the usual entries available in
both fields, you will find all the Sounds you have configured as send effects. For each of
them, the entry shows the Group letter followed by the Sound name (in the example un-
derneath we selected the entry
7.
Use Knob 6
(AUX 1
sent to that auxiliary output.
button to enter the Control mode.
A–H
A–H
of the Group containing that Sound, and press
(Button 4) is deactivated to show the Properties.
OUTPUT) or Knob 7
(AUX 2
D: REVERB
for the
LEVEL) or Knob 8
(AUX 2
↑9.4.1, Setting up a Sound as Send
corresponding to the desired Group.
OUTPUT) to assign the corresponding
AUX 1
output).
LEVEL) to adjust the level of the signal
MASCHINE MIKRO MK2 - Manual - 258
Using Effects
Creating a Send Effect
Advertisement
Table of Contents
