Native Instruments MASCHINE MIKRO MK2 Manual page 220

The Filter in the software.
Parameter
Type
Mode
Freq
Cut
Res
Modulation
Amount
Source
Source: LFO
Speed
Shape
Source: LFO Sync
Speed
Shape
Phase
Description
Here you can select between four different filter modes: LP (low-pass), BP
(band-pass), HP (high-pass), and Notch. Depending on the mode selected,
the following parameters vary as indicated.
Cut stands for cutoff frequency and is available with all filter modes.
Res controls the amount of resonance, i.e. the amount of amplification
near the cutoff frequency. It is not available with filter mode Notch.
This defines how much the Filter gets modulated by the modulation
source.
Here you can select between three different modulation sources: LFO, LFO
Sync, and Envelope. Depending on your choice for the modulation source,
the following parameters appear to the right:
Defines the speed of the modulation in hertz ranging from 0.03 Hz up to
16 Hz.
Change the shape of the LFO waveform here.
Defines the speed of the modulation in note values from 16/1 (one cycle
every 16 bars) up to 1/32 note.
Change the shape of the LFO waveform here.
Adjusts the start phase of the LFO.
MASCHINE MIKRO MK2 - Manual - 220
Effect Reference
Filtering Effects