Table of Contents
Advertisement
Controller
Controller Installation
The Controller mounts in the controller housing located on the left side of the CPS shelf, Figure 5-5. The
Controller is field installable, however in most cases it will be factory installed.
Warning: You must properly protect the Controller against ESD discharge.
Note: There is an ESD cord connection located on the left side of the shelf.
Step
Action
1.
Does the CPS shelf have the Controller already installed?
Yes - Proceed to the Rectifier
Installation section
Slide the controller into the shelf until it is fully seated in the connector on the rear of the CPS shelf. See
2.
Figure 5-5.
Connect one end of the display cable to the connector on the controller. Connect the display faceplate to
3.
the other end of the display cable. Carefully dress the display cable when attaching to the shelf to ensure
the cable does not get pinched.
4.
Insert the tab on the bottom of the faceplate into the slot on the bottom of the controller housing.
5.
Push the display faceplate into the shelf until the latch on the top of the controller housing catches.
Page 41
© Copyright 2021 ABB. All rights reserved.
No - Continue
ESD Strap Connector
ESD Strap Connector
Slide the controller
into the shelf
Advertisement
Table of Contents
