Table of Contents
Advertisement
DHCP
Gateway
DNS
Mail Server
Write Access
System Info
This section of the menu displays various high level system status.
Controller Info
Date
Time
Ambient Temperature
Control/Operations
The following are the system control and operation functions that can be performed from the front
panel. These operations are generally used in post installation and maintenance modes.
Start Lamp Test
Restart Devices
Clear Events
Uninstall Equipment
Page 109
© Copyright 2021 ABB. All rights reserved.
This field indicates the operational mode of the integrated Ethernet port. The port can be
operating as a DHCP Client, Static Client, or a DHCP Server. DHCP Server is the default mode
of operation for NX400 Craft port and Static is the default for the LAN port.
This address is for the address of the Gateway or node on the network that will serve as the
entrance to another network for the QS841. This address should be the address of the
equipment or computer that routes the traffic from and to the QS841 to the outside network.
It is generally the proxy server. The format for the Gateway address field is a 32-bit numeric
address written as four numbers separated by periods (ddd.ddd.ddd.ddd). Each number
digit, d, can be zero to 255.
Address of the Domain Name Server that translates domain names into IP addresses. This
field is of the format ddd.ddd.ddd.ddd.
The address for the computer or equipment within the network that will manage the QS841
e-mails. The format for the Gateway address field is a 32-bit numeric address written as four
numbers separated by periods
(ddd.ddd.ddd.ddd). Each number digit, d, can be zero to 255.
This field shows whether the port has bee configured to allow Read/Write access or Read
Only access. Read/Write access is available when the feature has been enabled.
Provides software versions for overall controller, boot block , display, and web pages. It also
provides the file used for factory defaults along with its version number. For the NX400, the
display is of the format (vNX.d.d).
System controller present date using configured format.
System controller present time using configured format.
System controller present temperature of its on-board sensor using configured format.
Temporarily illuminates all status indicators of attached rectifiers, distribution monitoring and
control modules and the system controller.
Provides the ability to restart "All" system serial controlled rectifiers at once or individually
resetting rectifiers or ringers. Does not affect rectifiers, ringers, and other system devices that
are already functioning.
Used to clear momentary events or alarms. It clears the following system alarms: Check
Battery, Reserve Time Low, Battery Voltage Imbalance
Clears alarms related to the removal of a system component such as a rectifier, thermal probe,
or voltage monitoring module.
Advertisement
Table of Contents
