Table of Contents
Advertisement
MIN, Battery High Temp
MIN, Rect Redundancy Loss
MIN, High Battery Current
MIN, Minor Communication Fail
MIN, Circuit Pack Failure
MIN, Mid-cell V Monitor Fail
If no alarms are active "NO ACTIVE ALARMS" is reported.
bye
Log-off
Syntax:
bye
Description
This command is used to terminate the session.
Cha
Change Value
Syntax:
cha obj,attr=value
where: obj,attr is an object-attribute pair. For example, ps1,sid.
Description
This command is used to change system configuration parameters. Examples are listed below to
illustrate how this command works.
cha ps1,sid="My Plant"Change the site id to My Plant
cha p1,phn="123456789"Change the primary phone number to 123456789 You must be logged in as a
super-user to use this command.
His
Report Alarm History
Syntax:
his Description Syntaxhis
where: obj,attr is an object-attribute pair as defined in the following:
sum dc1,adc- report plant load current statistics
sum br1,hbt- report highest battery temperature statistics
His
Report Boost History
Syntax: his Description Syntaxhis
where: obj,attr is an object-attribute pair as defined in the following: sum dc1,adc- report plant load
current statistics
sum br1,hbt- report highest battery temperature statistics
his
Report Boost History
Syntax: his bs1,stt
Page 167
© Copyright 2021 ABB. All rights reserved.
Advertisement
Table of Contents
