Table of Contents
Advertisement
Rectifier Installation
Install the Rectifier
This procedure is used to install the rectifier in the CPS6000 shelf. Figure 5-15 is a 23-inch shelf with 4
rectifier positions and a Single-Slot Distribution Module.
Note: All rectifier ac and dc connections are made when rectifiers are seated in the shelf. Rectifiers will
power up when ac is applied to the shelf.
Step
Action
Before engaging the rectifier connector into the back of the rectifier slot, press the Latch release button,
1.
the latch will spring open. See Figure 5-15.
Firmly push the rectifier into the rectifier slot until the connector on the rear of the rectifier engages
2.
with the connector at the back of the rectifier slot on the CPS shelf. The latch will pop most of the way
up when the rectifier is properly seated. Push the latch up into the latched position.
3.
Repeat until all rectifiers are installed.
Page 55
© Copyright 2021 ABB. All rights reserved.
C.O. Ground
Figure 5-14b: C.O. Ground Conductor Connection
Advertisement
Table of Contents
