Table of Contents
Advertisement
Connect to Site
To connect to the CPS6000 controller, hit F12 or from the Connect menu, select the Connect to Site
option. You may now select one of the listed sites. EasyView will start the connect process and display
the commands it is sending to the CPS6000 controller and responses it is getting back. When the
connection process is completed, EasyView will obtain the alarms and warnings of the CPS6000
controller and display them on the default screen.
Navigating Once Connected
Once you've connected to the controller, you should see the following screen. Note that any alarms
currently on the plant will be visible.
There are three pull-down menus you may choose to gain access to plant features and functions. They
are Configure, Control, and Status.
Configure
This pull-down menu allows one to access all CPS6000 controller parameters that may be uniquely
configured. It allows access to set alarm thresholds and alarm relays, set battery connect and
disconnect thresholds, enable auto-boost mode and set boost charge thresholds, change passwords,
enable imminent shutdown feature, set rectifier parameters, configure serial ports, and configure
slope thermal compensation.
Control
This pull-down menu allows one to access all CPS6000 controller parameters that may be activated to
perform a function. It allows one to perform a plant battery test, clear all clearable alarms, perform a
lamp test, change the plant state from float to boost mode, and inhibit or restart rectifiers.
Page 190
© Copyright 2021 ABB. All rights reserved.
Advertisement
Table of Contents
