Auxiliary Alarms - ABB CPS6000 Product Manual

Auxiliary Alarms

Distribution Module
Four auxiliary alarm inputs are provided, auxiliary inputs 1 through 4, and are configurable through
RS-232 interface of the controller. Auxiliary alarm inputs can be made on the AMM board. Remove the
Distribution Module side cover and AMM board for access to the connector as shown. The auxiliary
alarm input connector pin assignments are shown below.
Auxiliary Alarm
Inputs Connector
Pin
1
2
3
4
5
*Alarms are generated by connecting alarm contact inputs to Vminus, typically through a clean relay contact from the monitored
device.
Mating connector information for this 4-pin connector is as follows:
Housing: Amp part number 1445022-4
Contact (on a strip): Amp part number 794606-2
Contact (loose piece): Amp part number 794610-2
Page 80
© Copyright 2021 ABB. All rights reserved.
Cable Routing
Figure 6-2: P5 Auxiliary Alarms Connector
Alarm*
Auxiliary 1
Auxiliary 2
Auxiliary 3
Auxiliary 4
Return (Vminus/Battery)
Alternate
Cable Routing