ABB CPS6000 Product Manual page 166

Call-Out
obj,attr Description
p1,phn Primary phone number
a1,phn Alternate phone number
Ringer Plant
obj,attr Description
Rp1,frq
Ringer output frequency
Rp1,vsp
Ringer boost voltage set-point
Rp1,ofe
Ringer offset enable
Rp1,va
Ringer output va
Additional T1.317 Commands
Ala Report Active Alarms
Syntax: ala
Description
This command reports all the active alarm conditions in the plant. One alarm message is listed per line
in the report. The table below lists the default alarm messages. Note that if user changes the severity
of the alarm, the corresponding change will show up in the alarm message. However, alarm conditions
with the RO severity will not be displayed, the rec command, discussed later, should be used.
Alarm Message
MAJ, Multiple Rectifier Fail
MAJ, Multiple AC Fail
MAJ, Battery On Discharge
MAJ, High Voltage
MAJ, Sense Fuse
MAJ, Fuse Major
MAJ, Auxiliary Major
MAJ, Contactor 1 Open
MAJ, Contactor 1 Fail
MAJ, Major Communication Fail
MAJ, High Battery Current Shutdown
MAJ, Shorted Cell Detected
MAJ, Imminent Low V Shutdown
MAJ, Open String
MIN, Rectifier Fail
MIN, AC Fail
MIN, Thermal Probe Fail
Page 166
© Copyright 2021 ABB. All rights reserved.
Related Commands
sta cha ope
x x
x x
Related Commands
sta cha ope
x x
x x
x x
x
type range of values
text Up to 20 characters:""
text Up to 20 characters:""
type range of values
number 15-50: 20 Hz
number 65-100: 100V
number 0: disable, 1: enable
number dd.d VA