ABB CPS6000 Product Manual page 75

Step Action
For QS841A only :
If network parameters have been obtained from the corporate network administrator and the controller
is ready to be configured for network operations follow the steps below: Otherwise the installation is
complete.
The following Network Configuration Parameters must be obtained from your Network Administrator
before starting:
IP address
7.
Subnet mask
Host name
Gateway IP address
Note: Host and Gateway may be optional.
Configuration of the network parameters may be done in one of two different ways:
Easy View
Serial Port
Configuring the network parameters for QS841A only :
Using EasyView
Using a PC with EasyView running connected to J3 of the QS841A go to Configure → Port
Communications → Network Port 1. Enter all network parameters and click "OK" to save. Serial Port
The appropriate IP address, subnet mask, hostname, and default gateway IP address must be configured
on the QS841A through serial port J3.
To login to the QS841A, follow these steps:
Start-up the PC terminal program (Windows Terminal, ProComm, etc.) using the following communication
parameters:
8
Baud : 9600
Data : 8 Parity : none Stop : 1
Handshaking: none Flow Control: none
Connect the PC to the QS841A local port (RS-232) connector J3
Wait for any diagnostic messages to pass.
Wait for the "ENTER PASSWORD:" command line prompt.
Type the Network Administrator password (default: administrator).
Wait for the "$" prompt.
Configuring Static Network Parameters
After a valid password entry, a login header with the following format similar to that below will be
displayed:
Board Code
Serial Number 05DJ09112345
8A Boot Block
Pages
Ethernet Address 00-60-1D-00-5C-07 IP Address not configured
Subnet Mask
Default Gateway
For assistance type help
Page 75
© Copyright 2021 ABB. All rights reserved.
QS841A
version 1.0 Application Code
not found
not configured
not configured Host Name
version 1.0 Default Web Pages version 1.0 Custom Web
not configured