Table of Contents
Advertisement
System Settings
Located here are the menus for configuring general system level settings.
Display Contrast
System Date and Time
Daylight Savings
Display T Units
High Ambient T
Low Ambient T
Communication Ports
Menus for configuring the following communication parameters:
Port Type
Local Port Settings
Modem Port Settings
Page 116
© Copyright 2021 ABB. All rights reserved.
Allows display backlight intensity to be adjusted for contrast in local ambient light. Factory
default is 50%.
Sets system date and format. The format for date can be selected from: mm/dd/yyyy, dd/
mm/yyyy, yyyy/mm/dd, mm-dd-yyyy, yyyy- mm-dd, dd-mm-yyyy, mm/dd/yy, yy/mm/dd, dd/
mm/yy, mm-dd-yy, yy-mm-dd, or dd-mm-yy and the format for time can be 12HR/24HR
format. The factory default is Date: mm/dd/yyyy and Time: 12HR.
Enable or disable. Factory default is Enabled.
°C or °F. Factory default is °C.
High temperature alarm threshold that can be set from 35°C to 75°C. The factory default
setting is 75°C.
Low temperature alarm threshold that can be set from -40°C to 10°C. The factory default
setting is -40°C.
Set the communication port to either Local or Modem. Factory default is Local. This
connection setting is required by the EBW in the NX400 system in order to provide
the SNMP management port.
Provides the ability to Enable or Disable Write access to the controller, the ability to
change system settings through the SNMP management or local port. The factory
default setting is enabled.
The baud rate, number of data bits, parity, number of stop bits, and flow control
parameters for the port is also configurable. These parameters have been factory
set to 9600, 8, none, 1, none, respectively, to facilitate communication between the
QS841A_NX1 and the EBW NIC.
Provides the ability to Enable or disable Write access, the ability to change system
settings through the modem. The factory default setting is Enabled.
The baud rate, number of data bits, parity, number of stop bits, and flow control
parameters for the port is also configurable. Note: the initialization string of the
external MODEM must be set in the controller. Factory default for the string is
"AT&FEV&C1S0=0H". This string can be modified by utilizing EasyView or T1.317
commands through a local terminal connection. Consult technical field support if
further assistance is required.
Thee number of rings to be detected by the modem before it answers (Rings to
Answer) can be set from 1 to 9. The factory default setting is 1.
Advertisement
Table of Contents
