Table of Contents
Advertisement
Ordering Information
Ordering Guide
An ordering guide may be downloaded from the ABB Power web site. This guide will augment the
information found here.
Note: Ordering information here is presented only from the viewpoint of miscellaneous item ordering
and may not be complete. Complete System ordering should done using the ordering guide only.
Comcodes
The CPS6000 can be ordered by 9-digit numeric character sets called comcodes. The following guides
you through the comcode selection process in creating a power system. Please refer to the product
description section on the individual components for more details.
Power Shelves
Shelves are available in 23-inch (584 mm) and 19-inch (483 mm) rail widths. Mounting hardware is
provided. Refer to Ordering Guide for other shelf types.
Baffle
A 1U tall baffle is available to mount between shelves, below the shelf or above the shelf. See Appendix
F for application information.
Distribution Modules
The Platform has standard single slot, dual slot, front bulk and rear bulk output module options. An
external 23" distribution panel is also available for systems with the bulk output. Battery breakers are
available in lieu of the battery straps. However, maximum current allowed through each battery breaker
is 50A instead of the 100A through the battery strap. For load breakers in a single slot distribution
module, a max of two 60A load breakers can be used. If only a single breaker is used in the topmost
position, a 70A breaker may be used
Office Alarm Cable
WARNING
Disconnect alarm cable before cutting it to length. Cutting the alarm cable while it is plugged into the
controller will damage the controller.
A cable assembly is available that mates to the host-interface connector on the controller allowing
access to alarms. This cable is terminated on one end with a connector that mates to the Distribution
Module host-interface connector, and un-terminated on the other end. Refer to the ordering guide for
cable lengths available
Distribution Module Circuit Breakers
The following bullet-style circuit breakers, which have been accepted for use in dc load and battery
applications, are available for the current Distribution Module. These breakers only alarm for a trip
condition. For a single slot distribution module, a max of two 60A load breakers can be used. If only a
single breaker is used in the topmost position, a 70A breaker may be used
Page 25
© Copyright 2021 ABB. All rights reserved.
Advertisement
Table of Contents
