Table of Contents
Advertisement
12.4.7 Pre-assembling the Upper Horizontal Support Structure
NOTE For larger configurations, it may be easier to pre-assemble the cantilever bracket
assemblies and mount them after the horizontal supports are installed. For smaller systems, it
is recommended to assemble as described below.
Cantilever Brackets
1. Cut the rubber to length (if necessary) and place it inside the clamp if desired or set aside
for later installation; install the bolt and nut.
2. Slide the clamp assembly onto the cantilever brackets.
3. Mount the cantilever brackets to the horizontal supports (top and bottom) using the wolf
washers (B), inserts (D), and break off bolts (E).
4. Lift and Install the horizontal support assembly to the upright posts.
FIGURE 12-9: Assembling the upper support structure
196
Inst. and Maint. Manual | Oxeo PR LCP | F_101921 Rev 02 | 10-2022 | en
Advertisement
Table of Contents
