Table of Contents
Advertisement
FIGURE 5-44: Checking the right angles
NOTICE Reduced service life and leaks from obliquely sawn pipe ends
Check the right angles of the saw cut. The angle tolerance is α = ± 0.5°.
FIGURE 5-45: Deburring pipe ends
NOTICE Reduced service life and leaks from sharp-edged pipe ends
Deburr the inner and outer pipe ends with a manual deburrer.
3. Clean pipes properly with compressed air.
120
Inst. and Maint. Manual | Oxeo PR LCP | F_101921 Rev 02 | 10-2022 | en
Advertisement
Table of Contents
