Assembling The Shuttle Non-Return Valve - Viking Oxeo Installation And Maintenance Manual

FIGURE 5-23: Assembling the electrical release device
1. Connector plug
2. Electric release device
13. Assemble the electrical release device on the quick release valve.
14. Assemble the monitoring of the electrical release device, see "Assembling the monitoring
of the electrical release device" on page 88.
15. Assemble the connector plug.

5.7 Assembling the shuttle non-return valve

Personnel:
•
Authorized Distributor
Protective equipment:
•
Safety goggles
Shuttle non-return valve must be installed wherever control gas may only flow in one direc-
tion, and a pneumatic component is activated through two pressure sources.
98
Inst. and Maint. Manual | Oxeo PR LCP | F_101921 Rev 02 | 10-2022 | en