Table of Contents
Advertisement
Straight minimum pipe length H
(without bending)
Minimum installation length
1
The straight pipe end must not deviate from the dimension tolerance of the pipe in accor-
dance with DINEN10305-1 regarding roundness and straightness in the entire zone "H" .
2
If twice the height of the union nut is a higher value, maintain the higher value.
Saw, deburr, and clean the pipe
FIGURE 5-43: Sawing device
1. Clamp the pipe in a sawing device so the pipe is not deformed.
2. Cut the pipe to length with a hacksaw. Do not use any pipe cutter or angle grinder.
Inst. and Maint. Manual | Oxeo PR LCP | F_101921 Rev 02 | 10-2022 | en
min
1
L
min
Pipe Outer Diameter
0.24 inches (6 mm)
0.39 inches (10 mm)
2
1.38 inches
1.58 inches
(35 mm)
(40 mm)
1.77 inches
1.97 inches
(45 mm)
(50 mm)
2
119
Advertisement
Table of Contents
