Table of Contents
Advertisement
1. Screw on both hexagonal union nuts until hand-tight by turning them to the right.
Do not use additional sealant.
2. Tightly screw both hexagonal union nuts by turning them to the right using a suitable tool
(e.g.an open-end wrench).
Do not go below the minimum bending radius (observe the documentation of the
flexible pilot hose).
Do not twist the hose in the longitudinal direction (torsion). If necessary, loosen the
hexagonal union nut and then the fasten the hose without torsion.
5.9 Assembling the pilot pressure relief device
Personnel:
•
Authorized Distributor
Protective equipment:
•
Safety goggles
•
Safety gloves
•
Safety footwear
102
Inst. and Maint. Manual | Oxeo PR LCP | F_101921 Rev 02 | 10-2022 | en
Advertisement
Table of Contents
