Table of Contents
Advertisement
Completion of the nozzle body and assembly of the nozzle may be carried out in various
sequences. Here, assembly of the nozzle body to the pipe network with immediate or subse-
quent completion is described.
Mounting the nozzle body
FIGURE 5-40: Mounting the orifice
1. Wrap the connection thread on the nozzle socket with a suitable sealant (e.g. PTFE sealing
tape).
2. Using a standard socket wrench on the wrench flats of the nozzle socket, firmly screw the
nozzle body into the fitting.
NOTE: Nozzle comes with all components assembled
Mounting the DCM style nozzle with gasket (optional)
The nozzle must be located 1' from the top of the enclosure in order to achieve proper distri-
bution of agent. The DCM nozzle is provided in either 1/2" NPT or 3/4" NPT thread on the inlet
and outlet. With proper installation material, the nozzle can be mounted from the outside in
bag houses, dust collectors, and machining centers. To prevent obstructions to the nozzle ori-
fice, the foil gasket must be used. The nozzle must be installed in the calculation area and
should never be directly over sensitive equipment or devices. Modifications to the DCM noz-
zles are not allowed.
116
Inst. and Maint. Manual | Oxeo PR LCP | F_101921 Rev 02 | 10-2022 | en
Advertisement
Table of Contents
