Table of Contents
Advertisement
Quick Entry MAP
Quick Entry MAP Table of Contents
Problem Description
Service actions
The rack indicator LED does not operate as described on "FRU Identify LEDs" on page
119.
The system attention LED on the operator panel is on.
OK does not appear in the operator panel display before pressing the power-on button.
Other symptoms appear in the operator panel display or LEDs before the power-on
button is pressed.
8-Digit error codes
System stops with an 8-digit number displayed
System stops with a 4-digit number displayed that does not begin with 0 or 2.
System stops with a 3-digit number displayed (see below for 888 sequence).
Hardware Management Console (HMC) Problem
There appears to be a display problem (distortion, blurring, etc.)
Power and cooling problems
888 sequence in operator panel display
Other symptoms or problems
Attention:
If you replace FRUs or perform an action on an I/O subsystem and the problem is still not
corrected, go to "MAP 1542: I/O Problem Isolation" on page 144 unless you were already directed to any
MAP 154x by the error code. Otherwise, call for support if the action(s) for an error code do not resolve
the problem.
If you replace FRUs or perform an action, and the problem is corrected, go to "MAP 410: Repair
Checkout" in the Eserver pSeries Diagnostic Information for Multiple Bus Systems.
Note: If the only service actions you perform are on the HMC do not use MAP 410 to do the repair
checkout.
Chapter 3. Maintenance Analysis Procedures
Page No.
78
78
78
78
79
79
79
79
79
80
81
81
81
77
Advertisement
Table of Contents
