Operator Panel Error Codes - IBM eserver p Series Service Manual

Operator Panel Error Codes

Attention: If you replace FRUs or perform an action on an I/O subsystem and the problem is still not
corrected, go to "MAP 1542: I/O Problem Isolation" on page 144 unless you were already directed to any
MAP 154x by the error code. Otherwise, call support if the action(s) for an error code do not resolve the
problem.
Attention: If the error code that brought you to this chapter originated in the operating system error log,
an error may require an additional 15 minutes to be propagated to the operating system error log.
If you replace FRUs and the problem is corrected, go to "MAP 0410: Repair Checkout" in the Eserver
pSeries Diagnostic Information for Multiple Bus Systems.
Error Code Description
0000 1111 At power on, failure of power-good signal from
power supply.
0000 1112 At power off, failure of power-good signal from
power supply.
0000 1113 While power on, failure of power-good signal
from power supply.
0000 1114 Operator panel and service processor have
been reset after main power disturbance.
0000 2222 Operator panel not communicating with service
processor
0000 3333 SPCN communications error
0000 3334 I2C repeater error
0000 BBBB TOD battery malfunction
248 EserverpSeries 650 Service Guide
Action/
Possible Failing FRU
1. Service processor/PCI backplane
Location: U0.1-P2
2. Power supply
Locations:
U0.1-V1
U0.1-V2
1. Service processor/PCI backplane
Location: U0.1-P2
2. Power supply
Locations:
U0.1-V1
U0.1-V2
1. Service processor/PCI backplane
Location: U0.1-P2
2. Power supply
Locations:
U0.1-V1
U0.1-V2
Information message
1. If system cannot be powered off, reset the
service processor (via the pinhole reset or
by disconnecting then reconnecting power).
2. Service processor/PCI backplane
Location: U0.1-P2
Service processor/PCI backplane
Location: U0.1-P2
Service processor/PCI backplane
Location: UO.1-P2
TOD battery
Location: U0.1-P2-V3