Table of Contents
Advertisement
Step 1523-7
1. Turn off the power.
2. Disconnect the ac power cables (dc power cables in a dc-powered system) from the base system
drawer.
3. Reinstall one of the cards that was removed in "Step 1523-1" on page 136, in the sequence listed:
a. Processor cards
b. RIO adapter card(s)
c. PCI adapter card(s)
d. DASD device(s)
e. Media bay device(s)
4. Reconnect the ac power cables (dc power cables in a dc-powered system) to the base system drawer.
5. Turn on the power.
Is the error code 1011 1B0x displayed?
No
Go to "Step 1523-8."
Yes
The last card you installed is defective. Replace the last card you installed. This ends the
procedure. Go to "MAP 0410: Repair Checkout" in the Eserver pSeries Diagnostic Information
for Multiple Bus Systems.
Step 1523-8
Have all the cards that were removed in "Step 1523-1" on page 136 been reinstalled?
No
Go to "Step 1523-7" and reinstall the next card in the list.
The symptoms have changed. This ends the procedure. Go to "MAP 0410: Repair Checkout" in
Yes
the Eserver pSeries Diagnostic Information for Multiple Bus Systems.
Chapter 3. Maintenance Analysis Procedures
139
Advertisement
Table of Contents
