Table of Contents
Advertisement
3. Lift the front of the EMC cover straight up. When the rear of the cover is clear of the rear bulkhead, lift
the cover out of the processor subsystem.
Replacement
1. Pull up on all the push-button snaps to ensure that they are all in the open position.
2. Place the EMC cover over the processor card section of the processor subsystem. The tabs on the
rear end of the cover should be under the tabs on the rear bulkhead. When the rear end of the cover
is in the correct position, push down on the cover and then the push-button latches to hold the cover in
place.
3. Install the top covers; see "PCI Adapter Cover" on page 549.
550
EserverpSeries 650 Service Guide
Advertisement
Table of Contents
