IBM eserver p Series Service Manual page 234

Table 2. Firmware Checkpoints (continued)
Checkpoint
E547
E548
E549
214 EserverpSeries 650 Service Guide
Description
Set up the I/O interface chip routing table
Disable any node mode
Disable the anynode mode
Action/
Possible Failing FRU
1. Replace the RIO cable specified by the
location code.
2. Replace the RIO connector card
(location: U0.dd-P1.1) in the failing I/O
subsystem. This is the I/O subsystem to
which the cable replaced in step 1 on
page 213 is attached.
3. If the location code associated with this
checkpoint specifies a PCI adapter
card, replace the adapter card.
4. Replace the I/O subsystem backplane
(location: U0.dd-P1) in the failing I/O
subsystem. This is the I/O subsystem to
which the cable replaced in step 1 on
page 213 is attached.
5. Go to "MAP 1542: I/O Problem
Isolation" on page 144.
1. Replace the RIO cable specified by the
location code.
2. Replace the RIO connector card
(location: U0.dd-P1.1) in the failing I/O
subsystem. This is the I/O subsystem to
which the cable replaced in step 1 is
attached.
3. If the location code associated with this
checkpoint specifies a PCI adapter
card, replace the adapter card.
4. Replace the I/O subsystem backplane
(location: U0.dd-P1) in the failing I/O
subsystem. This is the I/O subsystem to
which the cable replaced in step 1 is
attached.
5. Go to "MAP 1542: I/O Problem
Isolation" on page 144.
1. Replace the RIO cable specified by the
location code.
2. Replace the RIO connector card
(location: U0.dd-P1.1) in the failing I/O
subsystem. This is the I/O subsystem to
which the cable replaced in step 1 is
attached.
3. If the location code associated with this
checkpoint specifies a PCI adapter
card, replace the adapter card.
4. Replace the I/O subsystem backplane
(location: U0.dd-P1) in the failing I/O
subsystem. This is the I/O subsystem to
which the cable replaced in step 1 is
attached.
5. Go to "MAP 1542: I/O Problem
Isolation" on page 144.