Table of Contents
Advertisement
Step 1547-8
Attention:
Before replacing the processor backplane, call for support.
Replace the processor backplane at U0.1-P1.
Step 1547-9
Turn on the power.
Step 1547-10
Did the system stop with the same error code as recorded in "Step 1547-1" on page 169?
No
The part just replaced was defective. This ends the procedure.
Return the system to its original configuration.
Go to "MAP 0410: Repair Checkout" in the Eserver pSeries Diagnostic Information for Multiple
Bus Systems.
Yes
Go to "Step 1547-11."
Step 1547-11
Turn off the power.
Step 1547-12
Call for support.
This ends the procedure.
MAP 1548: Memory and Processor Problem Isolation
Step 1548-1
Record the error code and the location code(s) that sent you to this MAP.
Step 1548-2
Turn off the power.
Step 1548-3
Replace the following cards, if present, one at a time:
v First location code item recorded, if any, in "Step 1548-1."
v Second location code item recorded, if any, in "Step 1548-1."
v Third location code item recorded, if any, in "Step 1548-1."
v Fourth location code item recorded, if any, in "Step 1548-1."
v If the error code recorded in "Step 1548-1" is of the form 450x xxxx or 4B2x xxxx then replace the
processor card at location U0.1-P1-C1, if not recorded in "Step 1548-1."
v If the error code recorded in "Step 1548-1" is of the form 450x xxxx or 4B2x xxxx then replace the
processor card at location U0.1-P1-C2, if not recorded in "Step 1548-1."
v If the error code recorded in "Step 1548-1" is of the form 450x xxxx or 4B2x xxxx then replace the
processor card at location U0.1-P1-C3, if not recorded in "Step 1548-1."
v If the error code recorded in "Step 1548-1" is of the form 450x xxxx or 4B2x xxxx then replace the
processor card at location U0.1-P1-C4, if not recorded in "Step 1548-1."
v If the error code recorded in "Step 1548-1" is of the form 4B2x xxxx then replace the processor bus
connector card at location U0.1-P3, if not recorded in "Step 1548-1."
v If the error code recorded in "Step 1548-1" is of the form 450x xxxx then replace all memory DIMMS on
processor card 1 at location U0.1-P1-C1-Mn (n equals 1 to 8), if not recorded in "Step 1548-1."
v If the error code recorded in "Step 1548-1" is of the form 450x xxxx then replace all memory DIMMS on
processor card 2 at location U0.1-P1-C2-Mn (n equals 1 to 8), if not recorded in "Step 1548-1."
v If the error code recorded in "Step 1548-1" is of the form 450x xxxx then replace all memory DIMMS on
processor card 3 at location U0.1-P1-C3-Mn (n equals 1 to 8), if not recorded in "Step 1548-1."
170
EserverpSeries 650 Service Guide
Advertisement
Table of Contents
