IBM eserver p Series Service Manual page 324

Table 6. Service Processor Error Codes. (continued)
Error Code Description
4065 0A06 Reboot message (run-time array gard failure)
for processor 3
4065 0B00 Problem with internal RIO interface (I/O slot 0,
I/O port 0)
4065 0B01 Problem with internal RIO interface (I/O slot 0,
I/O port 1)
4065 0B02 Problem with RIO interface (I/O slot 0, I/O port
2)
304 EserverpSeries 650 Service Guide
Action/
Possible Failing FRU
Array bit steering, which is a function in the
firmware, may be able to correct this problem
without replacing hardware.
If AIX is available on the system, go to MAP
0235 in the Eserver pSeries Diagnostic
Information for Multiple Bus Systems, order
number SA38-0509.
If Linux is the only operating system on the
system, schedule deferred maintenance with
the customer. When it is possible to reboot the
system, do the following:
1. Using the service processor's system power
control menu, disable fast mode boot.
(Disabling fast mode automatically enables
slow mode.)
2. Boot the AIX diagnostic CD-ROM.
3. Run diagnostics in problem determination
mode. If no errors are recorded against any
of the processors (devices with a resource
name of procx), array bit steering was
successful and the problem has been
corrected.
If errors are reported against the hardware,
follow the actions for the error code or SRN.
1. Check for system firmware updates.
2. RIO riser card,
Location: U0.1-P1-H1
3. Service processor/PCI backplane,
Location:U0.1-P2
4. System board,
Location: U0.1-P1
1. Check for system firmware updates.
2. RIO riser card,
Location: U0.1-P1-H1
3. Service processor/PCI backplane,
Location:U0.1-P2
4. System board,
Location: U0.1-P1
1. Check for system firmware updates.
2. Check the cabling between the RIO
interface card at U0.1-P1-H1 and the I/O
subsystems.
3. RIO riser card,
Location: U0.1-P1-H1
4. Call service support.