IBM eserver p Series Service Manual page 403

Table 6. Service Processor Error Codes. (continued)
Error Code Description
406D 0A05 Reboot message (run-time array gard failure)
for processor 1
406D 0A06 Reboot message (run-time array gard failure)
for processor 3
Action/
Possible Failing FRU
Array bit steering, which is a function in the
firmware, may be able to correct this problem
without replacing hardware.
If AIX is available on the system, go to MAP
0235 in the Eserver pSeries Diagnostic
Information for Multiple Bus Systems, order
number SA38-0509.
If Linux is the only operating system on the
system, schedule deferred maintenance with
the customer. When it is possible to reboot the
system, do the following:
1. Using the service processor's system power
control menu, disable fast mode boot.
(Disabling fast mode automatically enables
slow mode.)
2. Boot the AIX diagnostic CD-ROM.
3. Run diagnostics in problem determination
mode. If no errors are recorded against any
of the processors (devices with a resource
name of procx), array bit steering was
successful and the problem has been
corrected.
If errors are reported against the hardware,
follow the actions for the error code or SRN.
Array bit steering, which is a function in the
firmware, may be able to correct this problem
without replacing hardware.
If AIX is available on the system, go to MAP
0235 in the Eserver pSeries Diagnostic
Information for Multiple Bus Systems, order
number SA38-0509.
If Linux is the only operating system on the
system, schedule deferred maintenance with
the customer. When it is possible to reboot the
system, do the following:
1. Using the service processor's system power
control menu, disable fast mode boot.
(Disabling fast mode automatically enables
slow mode.)
2. Boot the AIX diagnostic CD-ROM.
3. Run diagnostics in problem determination
mode. If no errors are recorded against any
of the processors (devices with a resource
name of procx), array bit steering was
successful and the problem has been
corrected.
If errors are reported against the hardware,
follow the actions for the error code or SRN.
Chapter 5. Error Code to FRU Index
383