Table of Contents
Advertisement
Return the system to its original configuration. Go to "MAP 0410: Repair Checkout" in the
Eserver pSeries Diagnostic Information for Multiple Bus Systems.
Yes
Go to "Step 1549-15."
Step 1549-15
Have all the cards listed in "Step 1549-12" on page 173 been replaced?
No
Go to "Step 1549-2" on page 172.
Yes
Go to "Step 1549-28" on page 175.
Step 1549-16
Replace the following cards, if present, one at a time:
v First location code item recorded, if any, in "Step 1549-1" on page 172.
v Second location code item recorded, if any, in "Step 1549-1" on page 172.
v Third location code item recorded, if any, in "Step 1549-1" on page 172.
v Processor card 3 at U0.1-P1-C3, if not recorded in "Step 1549-1" on page 172.
Processor card 4 at U0.1-P1-C4, if not recorded in "Step 1549-1" on page 172.
v
v Service processor/PCI backplane at U0.1-P2, if not recorded in "Step 1549-1" on page 172.
Step 1549-17
Turn on the power.
Step 1549-18
Did the system stop with the same error code as recorded in "Step 1549-1" on page 172?
No
The card just replaced was defective. This ends the procedure.
Return the system to its original configuration. Go to "MAP 0410: Repair Checkout" in the
Eserver pSeries Diagnostic Information for Multiple Bus Systems.
Yes
Go to "Step 1549-19."
Step 1549-19
Have all the cards listed in "Step 1549-16" been replaced?
No
Go to "Step 1549-2" on page 172.
Yes
Go to "Step 1549-28" on page 175.
Step 1549-20
Replace the following cards, if present, one at a time:
v First location code item recorded, if any, in "Step 1549-1" on page 172.
v Second location code item recorded, if any, in "Step 1549-1" on page 172.
v Third location code item recorded, if any, in "Step 1549-1" on page 172.
v RIO connector card 1 at location U0.1-P1-H1, if not recorded in "Step 1549-1" on page 172.
v RIO extender card 1 at location U0.1-P1-H1.1, if not recorded in "Step 1549-1" on page 172.
v RIO connector card 1 at location U0.1-P1-H2, if not recorded in "Step 1549-1" on page 172.
v RIO extender card 2 at location U0.1-P1-H2.1, if not recorded in "Step 1549-1" on page 172.
v Service processor/PCI backplane at U0.1-P2, if not recorded in "Step 1549-1" on page 172.
Step 1549-21
Turn on the power.
Step 1549-22
Did the system stop with the same error code as recorded in "Step 1549-1" on page 172?
174
EserverpSeries 650 Service Guide
Advertisement
Table of Contents
