IBM eserver p Series Service Manual page 312

Table 6. Service Processor Error Codes. (continued)
Error Code Description
4064 00B7 Insufficient hardware resources were detected
to continue IPL of the system after processor
subsystem testing and initialization was
completed
4064 00D1 Informational message
4064 0100 Memory extender 0 on processor card 1
4064 0101 Memory extender 2 on processor card 1
4064 0110 Memory extender 0 on processor card 2
4064 0111 Memory extender 2 on processor card 2
4064 0120 Memory extender 0 on processor card 4
4064 0121 Memory extender 2 on processor card 4
4064 0130 Memory extender 0 on processor card 3
4064 0131 Memory extender 2 on processor card 3
4064 0A03 Reboot message (run-time array gard failure)
for processor 0
292 EserverpSeries 650 Service Guide
Action/
Possible Failing FRU
Go to "MAP 1540: Problem Isolation
Procedures" on page 140.
Informational message
Processor card,
Location: U0.1-P1-C1
Processor card,
Location: U0.1-P1-C1
Processor card,
Location: U0.1-P1-C2
Processor card,
Location: U0.1-P1-C2
Processor card,
Location: U0.1-P1-C4
Processor card,
Location: U0.1-P1-C4
Processor card,
Location: U0.1-P1-C3
Processor card,
Location: U0.1-P1-C3
Array bit steering, which is a function in the
firmware, may be able to correct this problem
without replacing hardware.
If AIX is available on the system, go to MAP
0235 in the Eserver pSeries Diagnostic
Information for Multiple Bus Systems, order
number SA38-0509.
If Linux is the only operating system on the
system, schedule deferred maintenance with
the customer. When it is possible to reboot the
system, do the following:
1. Using the service processor's system power
control menu, disable fast mode boot.
(Disabling fast mode automatically enables
slow mode.)
2. Boot the AIX diagnostic CD-ROM.
3. Run diagnostics in problem determination
mode. If no errors are recorded against any
of the processors (devices with a resource
name of procx), array bit steering was
successful and the problem has been
corrected.
If errors are reported against the hardware,
follow the actions for the error code or SRN.