3. Perform the top cover removal procedure; see "Processor Subsystem Top Covers" on page 549.
Note: Leave the system in the service position after removing the top covers.
4. Remove the disk drives and the disk drive fillers as described in the removal procedure under "Disk
Drive Assembly" on page 628.
5. If installed, remove the SCSI repeater card as described in the removal procedure under "SCSI
Repeater Card" on page 631.
6. Remove the screws that hold card mounting plate.
7. Remove the screws that hold the mid-cover plate.
6
5
4
1 Air cover
2 Screw
3 PCI adapter cassette bracket
632
EserverpSeries 650 Service Guide
1
2
3
4 Screw
5 Front cover plate
6 SCSI Repeater Card