IBM eserver p Series Service Manual page 717

Appendix D. Modem Configurations
Attention: This appendix applies only to modems attached to the serial ports (S1 and S2) on the
primary I/O book (location U1.18-P1-H2).
These configuration files do not apply to the modem attached to the IBM Hardware Management Console
for pSeries (HMC).
Sample Modem Configuration Files
This appendix contains information about several sample modem configuration files that either work
directly with your modem or provide a good starting point for a custom setup.
The sample modem configuration files are located in the firmware in /usr/share/modems subdirectory (if
your server is using AIX) with the following names. A listing of each specific file is included in this
appendix.
Generic Modem Configuration Files
AIX File Name
modem_z.cfg
modem_z0.cfg
modem_f.cfg
modem_f0.cfg
modem_f1.cfg
Specific Modem Configuration Files
AIX File Name
modem_m0.cfg
modem_m1.cfg
Use the following selection procedures and your modem manual to determine which of the configuration
files is suitable for your use.
Service Processor Firmware File Name
modem_z_sp
modem_z0_sp
modem_f_sp
modem_f0_sp
modem_f1_sp
Service Processor Firmware File Name
modem_m0_sp
modem_m1_sp
697