IBM eserver p Series Service Manual page 251

Table 2. Firmware Checkpoints (continued)
Checkpoint
E59E
E59F
E5E0
E5E1
E5E2
E5E3
Description
End of walking bus of current EADS
End of EADS initialization
Initialize system processor array
Reserved
Initialization of the hypervisor, phase 1
Not in quick-restart: load and set up open
firmware code in memory
Action/
Possible Failing FRU
1. Check for system firmware updates.
2. Replace the RIO connector card
(location: U0.dd-P1.1) in the failing I/O
subsystem specified by the location
code.
3. If the location code associated with this
checkpoint specifies a PCI adapter
card, replace the adapter card.
4. Replace the I/O subsystem backplane
(location: U0.dd-P1) in the failing I/O
subsystem specified by the location
code.
5. Go to "MAP 1542: I/O Problem
Isolation" on page 144.
1. Check for system firmware updates.
2. Replace the RIO connector card
(location: U0.dd-P1.1) in the failing I/O
subsystem specified by the location
code.
3. If the location code associated with this
checkpoint specifies a PCI adapter
card, replace the adapter card.
4. Replace the I/O subsystem backplane
(location: U0.dd-P1) in the failing I/O
subsystem specified by the location
code.
5. Go to "MAP 1542: I/O Problem
Isolation" on page 144.
1. Check for system firmware updates.
2. Replace the RIO connector card
(location: U0.dd-P1.1) in the failing I/O
subsystem specified by the location
code.
3. Replace the I/O subsystem backplane
(location: U0.dd-P1) in the failing I/O
subsystem specified by the location
code.
4. Go to "MAP 1542: I/O Problem
Isolation" on page 144.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 144.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 144.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 144.
Chapter 4. Checkpoints
231