IBM eserver p Series Service Manual page 300

Error Code Description
2601 0000 Boot failed because the RIO cables, or the
power subsystem cables, are not routed
correctly to the I/O subsystems
2601 0001 Boot failed because the I/O subsystem has not
been programmed correctly.
2601 0002 RIO cable error
2602 0001 Invalid PCI adapter vendor ID
280 EserverpSeries 650 Service Guide
Action/
Possible Failing FRU
1. Check both ends of the RIO cable specified
in the location code that appears with this
error code.
2. Determine which I/O subsystem is at the
end of the RIO cable specified by the
location code shown with this error code.
Check both ends power supplies in that I/O
subsystem.
For information about I/O cabling and
connector locations, see "Subsystem
Positioning and Cabling" on page 11.
For information about I/O book cabling and
connector locations, see "Subsystem
Positioning and Cabling" on page 11.
1. Ensure that power cables are correctly
connected to the I/O drawers.
2. Firmware, including power code, may have
to be flashed on the I/O subsystem.
Note: The location code identifies the I/O
subsystem that has the problem
3. Contact the next level of support.
1. Check both ends of the RIO cable specified
in the location code that appears with this
error code.
2. Determine which I/O subsystem is at the
end of the RIO cable specified by the
location code shown with this error code.
Check the power cables going to both
power supplies in that I/O subsystem.
For information about I/O cabling and
connector locations, see "Subsystem
Positioning and Cabling" on page 11.
1. Move adapter to another slot (behind a
different PCI bus).
2. Check for available firmware updates for
adapter. Apply update if available.
3. Run AIX diagnostics on adapter. Replace if
indicated.
4. Replace adapter.
5. Check for system firmware updates. Apply if
update available.
6. Replace service processor/PCI backplane
(See notes on Chapter 5, "Error Code to
FRU Index," on page 241.)