IBM eserver p Series Service Manual page 358

Table 6. Service Processor Error Codes. (continued)
Error Code Description
4068 0EBF Memory error
4068 0EE1 Service processor firmware: invalid MRU to
FRU mapping
4068 0EE2 Service processor firmware fault
4068 0EE5 Firmware error, no callout available
4069 0002 System backplane fault
4069 0003 Scan interface basic assurance tests detected
processor fault
4069 0004 Scan interface basic assurance tests detected
processor fault
4069 0005 Scan interface basic assurance tests detected
processor fault
4069 0006 Scan interface basic assurance tests detected
processor fault
4069 0009 Processor bus connector card
338 EserverpSeries 650 Service Guide
Action/
Possible Failing FRU
1. Reboot the system in slow mode to the
SMS menus. See "Performing Slow Boot"
on page 241.
2. Examine the service processor error log.
a. If a CEC subsystem error (a 4xxx yyyy
error) occurred during the slow boot that
calls out the memory, processors, L3
cache modules or the primary I/O book,
replace the part indicated by the
location code.
b. If a CEC subsystem error (a 4xxx yyyy
error) did not occur during the slow
boot, look for a 4xxx yyyy error
immediately preceding the 406x 0EBF
error. Replace the part indicated by the
location code associated with that error.
1. Check for system firmware updates.
2. Call service support.
1. Check for system firmware updates.
2. Call service support.
1. Check for system firmware updates.
2. Call service support.
1. Ensure processor cards are seated and
cables are connected securely.
2. System backplane
Location: U0.1-P1
1. Ensure processor cards are seated and
cables are connected securely.
2. Processor card
Location: U0.1-P1-C1
1. Ensure processor cards are seated and
cables are connected securely.
2. Processor card
Location: U0.1-P1-C2
1. Ensure processor cards are seated and
cables are connected securely.
2. Processor card
Location: U0.1-P1-C3
1. Ensure processor cards are seated and
cables are connected securely.
2. Processor card
Location: U0.1-P1-C4
1. Ensure processor cards are seated and
cables are connected securely.
2. Processor bus connector card
Location: U0.1-P3