Table of Contents
Advertisement
This option is used to change the speed of the RIO interface to external drawers. On this system,
setting this speed will have no effect on the system.
The hardware capability is detected and set by the system firmware during the boot process. If the
hardware capability is uninitialized (after NVRAM is cleared), it will be set during the first boot and
remain set during subsequent boots.
The maximum RIO speed setting will remain uninitialized until set by the user.
The user can set the speed lower than or equal to the hardware capability, but not higher. If the
hardware capability is 1000 Mbps, the user can set the link speed to 500 Mbps, and the RIO link will
run at 500 Mbps. However, if the hardware capability is 500 Mbps and the user selects 1000 Mbps, the
user's selection will be ignored by the system.
If this option is chosen, the menu similar to the following is displayed:
Remote I/O (RIO) Link Speed Set Up Menu
Hardware Capability (internal and external): 1000 Mbps
1. Maximum RIO speed setting (internal and external):
Currently Uninitialized
98. Return to previous menu.
0>1
If option 1 is selected, the RIO interface speed can be set as follows:
Enter new value for this option: (1 = 1000 MBPS, 2 = 500 Mbps)
0>
This setting remains in effect until it is changed or NVRAM is cleared.
Language Selection Menu
The service processor menus and messages are available in various languages. This menu allows
selecting languages in which the service processor and system firmware menus and messages are
displayed.
LANGUAGE SELECTION MENU
1. English
2. Francais
3. Deutsch
4. Italiano
5. Espanol
98. Return to Previous Menu
99. Exit from Menus
0>
Note: Your virtual terminal window must support the ISO-8859 character set to correctly display
languages other than English.
Chapter 7. Using the Service Processor
499
Advertisement
Table of Contents
