Table of Contents
Advertisement
Step 1541-7
Turn off the power.
Step 1541-8
Attention:
Before replacing the processor backplane, call for support.
Replace the processor backplane at U0.1-P1.
Step 1541-9
Turn on the power.
Step 1541-10
Did the system stop with the same error code as recorded in "Step 1541-1" on page 141?
No
The card just replaced was defective. This ends the procedure.
Return the system to its original configuration.
Go to "MAP 0410: Repair Checkout" in the Eserver pSeries Diagnostic Information for Multiple
Bus Systems.
Yes
Go to "Step 1541-11."
Step 1541-11
Turn off the power.
Step 1541-12
Call for support.
This ends the procedure.
Step 1541-13
Turn off the power.
Remove the following cards, if present
v Processor card at location U0.1-P1-C2.
v Processor card at location U0.1-P1-C3.
v Processor card at location U0.1-P1-C4.
v Processor bus connector at location U0.1-P3.
v RIO connector card 1 at location U0.1-P1-H1.
v RIO extender card 1 at location U0.1-P1-H1.1.
v RIO connector card 2 at location U0.1-P1-H2.
v RIO extender card 1 at location U0.1-P1-H2.1.
Step 1541-14
Turn on the power.
Step 1541-15
Did the system stop with the same error code as recorded in "Step 1541-1" on page 141?
No
One of the cards just replaced is defective. Go to "Step 1541-16"
Yes
Go to "Step 1541-25" on page 143.
Step 1541-16
Turn off the power.
142
EserverpSeries 650 Service Guide
Advertisement
Table of Contents
