IBM eserver p Series Service Manual page 224

Table 2. Firmware Checkpoints (continued)
Checkpoint
E507
E508
E509
E50A
E50B
E50C
E50D
E50E
E50F
E51F
E520
E521
204 EserverpSeries 650 Service Guide
Description
I/O hub assignment
Begin initializing I/O hubs
Begin configuring EADS chips in I/O
subsystems
Check for missing I/O interface chips
Save I/O hub information
Copy all of the memory ranges
Copy all of the I/O data
Copy all of the I/O hub information
Clean up the error registers
End of I/O configuration
Set up the I/O architecture registers
Set up interrupts for the current I/O hub
Action/
Possible Failing FRU
1. Check for system firmware updates.
2. Replace the RIO adapter specified by
the location code.
3. Go to "MAP 1542: I/O Problem
Isolation" on page 144.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 144.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 144.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 144.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 144.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 144.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 144.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 144.
1. Check for system firmware updates.
2. Replace the RIO adapter specified by
the location code.
3. Go to "MAP 1542: I/O Problem
Isolation" on page 144.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 144.
1. Check for system firmware updates.
2. Replace the RIO adapter specified by
the location code.
3. Go to "MAP 1542: I/O Problem
Isolation" on page 144.
1. Check for system firmware updates.
2. Replace the RIO adapter specified by
the location code.
3. Go to "MAP 1542: I/O Problem
Isolation" on page 144.