Map 1549: Attention Problem Isolation - IBM eserver p Series Service Manual

Hide thumbs Also See for eserver p Series:

Table of Contents

MAP 1549: Attention Problem Isolation

Record the error code and the location code(s) that sent you to this MAP.

Turn off the power.

Examine the following table and locate the error code that sent you to this MAP to determine your next

Replace the following cards if present, one at a time:

v First location code item recorded, if any, in "Step 1549-1."

v Second location code item recorded, if any, in "Step 1549-1."

Third location code item recorded, if any, in "Step 1549-1."

v Processor card 1 at U0.1-P1-C1, if not recorded in "Step 1549-1."

Processor card 2 at U0.1-P1-C2, if not recorded in "Step 1549-1."

v Processor card 3 at U0.1-P1-C3, if not recorded in "Step 1549-1."

v Processor card 4 at U0.1-P1-C4, if not recorded in "Step 1549-1."

v Service processor/PCI backplane at U0.1-P2, if not recorded in "Step 1549-1."

Turn on the power.

Did the system stop with the same error code as recorded in "Step 1549-1"?

The card just replaced was defective. This ends the procedure.

Return the system to its original configuration.

Go to "MAP 0410: Repair Checkout" in the Eserver pSeries Diagnostic Information for Multiple

Bus Systems.

Go to "Step 1549-7" on page 173.

EserverpSeries 650 Service Guide

Go to "Step 1549-4."

Go to "Step 1549-8" on page 173.

Go to "Step 1549-12" on page 173.

Go to "Step 1549-24" on page 175.

Go to "Step 1549-20" on page 174.

Go to "Step 1549-24" on page 175.

Go to "Step 1549-16" on page 174.

Go to "Step 1549-24" on page 175.

Eserver p650