IBM eserver p Series Service Manual page 557

If List All Devices is selected, a menu similar to the following displays, depending on the devices that are
installed in the system:
Select Device
Device Current Device
Number Position Name
1. 1 SCSI 18200 MB Harddisk (loc=U0.1-P2/Z1-A8,0)
2. - SCSI 18200 MB Harddisk (loc=U0.1-P2/Z1-A9,0)
3. - SCSI 18200 MB Harddisk (loc=U0.1-P2/Z1-Aa,0)
4. None
5. List all devices
--------------------------------------------------------------------------------------------------
Navigation keys:
M = return to main menu
ESC key = return to previous screen
--------------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigation key: _
The appropriate device can then be selected for this boot or installation.
When a device is selected for installing the operating system, or to boot from, the Select Task menu allows
you to get more information about the device, or to boot from that device in normal mode or service mode.
The following is an example of this menu.
Select Task
SCSI 18200 MB Harddisk (loc=U0.1-P2/Z1-A8,0)
1. Information
2. Normal Mode Boot
3. Service Mode Boot
--------------------------------------------------------------------------------------------------
Navigation keys:
M = return to main menu
ESC key = return to previous screen
--------------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigation key: _
If either Normal Mode Boot or Service Mode Boot is selected, the next screen will ask, "Are you sure?". If
you answer yes, the device will be booted in the appropriate mode. If you answer no, the firmware will
return to the Select Task menu.
X = eXit System Management Services
X = eXit System Management Services
Chapter 8. Using System Management Services
537