Table of Contents
Advertisement
Reloading after a specific amount of time
To schedule a system reload to occur after a specific amount of time has passed on
the system clock, use one of the following methods.
To schedule a system reload from the secondary flash one day and 12 hours later,
enter the following command at the Privileged EXEC level of the CLI:
Syntax: reload after <dd:hh:mm> [primary | secondary]
<dd:hh:mm> is the number of days, hours, and minutes.
primary | secondary specifies whether the reload is to occur from the primary
code flash image or the secondary code flash image.
Diagnostic error codes and remedies for TFTP transfers
If an error occurs with a TFTP transfer to or from a B48C or B50C, one of the
following error codes are displayed.
58
IBM Ethernet Switch c-series Installation and User Guide
NetIron# reload after 01:12:00 secondary
Table 14. Error codes, messages, explanations and actions
Error code
1
2
3
4
5
6
Message
Flash read preparation failed. A flash error occurred during
Flash read failed.
Flash write preparation
failed.
Flash write failed.
TFTP session timeout.
TFTP out of buffer space.
Explanation and action
the download.
Retry the download. If it fails
again, contact customer
support
TFTP failed because of a
time out.
Check IP connectivity and
make sure the TFTP server is
running.
The file is larger than the
amount of space on the
device or TFTP server.
If you are copying an image
file to flash, first copy the
other image to your TFTP
server, then delete it from
flash. (Use the erase
flash... CLI command at
the Privileged EXEC level to
erase the image in the flash.)
If you are copying a
configuration file to flash,
edit the file to remove
unneeded information, then
try again.
Advertisement
Table of Contents
