9.2 How to remove the rear panels
9.2.1 To remove the
upper rear panels
B
A
M1207026
M1207027
Reproduced from the electronic master in MATRIX
You must remove the rear panels to repair or replace many of the
machine's components.
1. Bleed all gas pressure from the machine (Section 9.1).
2. Ensure that all cylinder and pipeline gauges read zero before
proceeding.
3. Disconnect all electrical cables.
4. To remove the large upper rear panel (A), fully loosen the eight
screws that hold the panel in place.
5. Remove the small upper rear panel (B) to access the access the
electrical enclosure.
004
MANUAL−DOC, Technical Reference Manual, Technical Reference Manual for 9100c, English
9 Repair Procedure
9-5