Adjust 01 Fine-Adjusting And Entering The Multifeeder Paper Width Basic Setting - Oce 3121 Technical & Service Manual

5 *3* ADJUST (adjustment mode)
Use this mode to fine-adjust or set back-up data needed for copying operations.
Use the keypad to enter numbers.
I
Press the
I
Record all new settings on the service label.
I
When done, turn off and then on the main power switch.
I
*3* ADJUST 01 Fine-Adjusting and Entering the Multifeeder Paper Width
Basic Setting
Item Description
Use it to fine-adjust or enter the mul-
tifeeder paper width basic setting.
MF-A6R MF-A6R:Indicates the stored A6R
(105mm) value of the multifeeder
paper width sensor.
MF-A4R MF-A4R:Indicates the stored A4R
(210mm) value of the multifeeder
paper width sensor.
MF-A4 MF-A4:Indicates the stored A4
(297mm) value of the multifeeder
paper width sensor.
36 TSM Océ 3121
key to accept the selected setting.
Remarks
If you have replaced the image
processor PCB, be sure to
enter the value recorded on the
service label.
For how to enter a new value
after replacement of the
paper width sensor, see serv-
ice handbook p. 2-15.
Settings
0~65535
SDS Description