Oce 3121 Technical & Service Manual page 117

Action in response to error codes
When the diagnostic system has switched ON, and an error has been logged,
the machine can be reset by switching the ON/OFF switch OFF, then ON.
E000, E001, E002, E003, E004, and E007–01, and E717 cannot be reset by
switching OFF and ON.
Resetting:
Go to "*4* FUNCTION" in service mode.
1
Press 'ERROR' on the LCD to highlight; then, press the OK key.
2
This will interrupt the mains supply for an instant.
I
In the case of 'E007', turning off and then on the main power switch will
Note:
activate film recovery mode ('FILM_COMEBACK' in service mode *4*),
thereby resetting the machine after returning the film to its correct position.
If the film fails to return to the correct position after executing this recovery
mode, 'E007-01' will be indicated. If this happens, replace the fixing assembly
or take appropriate measures, return the film to its correct position, and exe-
cute 'ERROR' in service mode (*4*).
Note that 'E007-01' in service mode will be indicated as 'E007', omitting the
last two digits under 'ERR' of 'DISPLAY' in service mode (*1*).
After the film has returned to normal position, following the execution of
'FILM COMEBACK', switch OFF, then ON: without touching the other but-
tons.
In the case of 'E202', the keys on the control panel will be locked without
Note:
indicating an error code; use 'ERR' under 'DISPLAY' in service mode (*1*)
if this is the case.
Operation in Response to an Error E5XX or E713 (12-bin output unit)
The copier's message display indicates "TURN ON POWER".
1
When the copier's power has been turned off and then on, the copier will reset
2
the error if the results of self diagnosis it has run are good. (it will indicate an
error code if any error is detected).
Copier operation with an Error Code On
The copier indicates 'E5XX' or 'E713'.
1
The copier allows making copies when the multi-tray is detached from it*.
2
A message will be displayed if a sorter application is selected.
3
* Turn off the joint sensor (MS3; feeding the multi-tray from the copier); you
need not disconnect the communication connector to the copier.
ed.2 Trouble shooting 9