Adjusting The Sheet Distance: In Image Composition Mode - Oce 3121 Technical & Service Manual

10 Adjusting the Sheet Distance: in Image Composition Mode

Adjust the sheet distance after "adjusting the height of the RDF" and "adjust-
ing the parallel transport 1 ."
Copier mode
Shift bits 1, 2, and 4 to ON: DIP switch (DSW1) on the RDF control PBA.
1
Place two sheets of A4 or LTR paper (80 g/m2) on the document tray.
2
Be sure to use A4 paper for an A/B-configured RDF and to use LTR paper for
an INCH-configured RDF.
Press once on the switch (SW3) on the RDF control PBA.
3
The paper will be picked up, and stopped on the platen.
I
Open the RDF slowly, and measure the distance l5 between the two sheets of
4
paper; then, close the RDF slowly.
platen
Paper
314 TSM Océ 3121
Paper
L5
Standards:
Sheet gap L5 = 0 ± 3 mm
Adjustments