Oce 3121 Technical & Service Manual page 40

Fitting the RDF
Ensure that the copier has been properly installed.
1
Keep the mains supply cable disconnected during the installation work.
2
Identify the screws by type (length, diameter, location).
3
Some screws come with a washer to protect against static electricity. Ensure
4
that these are used.
Lift the platen cover, and remove it from the copier.
1
Remove the two screws, and remove the platen retainer from the right-hand
2
side. Then, install the guide base to the right side of the copier (2 screws).
platen strip
Assemble the tray hinge and the hinge cover to the delivery tray. Then, install
3
the unit (2 screws).
hinge cover
.
ed.1
screws
guide
screw
Screw (M4 x 30):
tray hinge
delivery tray
Installation 33