Oce 3121 Technical & Service Manual page 317

Use the switches SW1 and SW2 on the RDF control PBA to adjust the trans-
5
port distance. Each press on the switch changes the sheet distance by 0.34 mm.
When the position is appropriate, press once on the switch SW3. The paper
will be ejected and the value will be stored.
Sheet gap
Push switch
SW1
SW2
After "adjusting parallel transport 1 ," "adjusting the parallel transport 2," "ad-
6
justing the transport distance," and "adjusting the sheet distance in image com-
position mode," switch off. Shift all bits to OFF: DIP switch (DSW1).
Switch ON, and check that the RDF functions correctly.
Shift bit 7 to ON: DIP switch (DSW1). Only if the document size (length
Note:
in feeding direction) is as follows:
RDF-configuration
A/B
INCH
Fax mode
Shift bits 1, 2, 4, and 5 to ON: DIP switch (DSW1) on the RDF control PBA.
1
Place two sheets of A4 or LTR paper (80 g/m2) on the document tray.
2
Be sure to use A4 paper for an A/B-configured RDF and to use LTR paper for
an INCH-configured RDF.
Press once on the switch (SW3) on the RDF control PBA.
3
The paper will be picked up, and stopped on the platen.
I
ed.1
Sheet gap
Increases
Decreases
Document size (length in feed-
ing direction)
220 to 250mm
220 to 260mm
10 RDF 315