Contents Contents Chapter 1 Instructions for safe use..................5 Instructions for safe use................6 Chapter 2 Regulation notices....................11 Regulation notices..................12 Chapter 3 General information..................17 General information (all countries)............18 Chapter 4 Miscellaneous....................19 Online support for your product.............20...
Note: Please refer to the corresponding Safety Data Sheets for specific safety information. You can download the Safety Data Sheets from the support site of your product at http://global.oce.com/support/. Warning and precaution symbols Warning: Ignoring this warning could cause serious injury or even death.
Page 7
Instructions for safe use Caution Ignoring this caution could cause injury to skin; see also the section "Actions in response to troubles". Warning Whenever this label is affixed to parts of the machine that are accessible to the user, a remark can be found in the user documentation, explaining the potential hazard for which the user is warned or cautioned.
Page 8
Instructions for safe use • Do not use any power cable other than the one provided. Never use the power cable with any other electrical device. Power source Warning • Put the power plug directly into a wall socket that has the same configuration as the plug.
Page 9
Instructions for safe use Ventilation Caution • The machine can produce odors of exhaust air when you: – use this machine in a poorly ventilated room for a long time – produce large amounts of copies or prints Therefore, make sure that you ventilate this room well. •...
Page 10
Instructions for safe use Moving the machine Caution • Make sure that you disconnect the power cord and other cables before you move the machine. • Make sure that you check the documentation for the space requirements before you move the machine. General use Caution •...
Regulation notices Regulation notices Introduction This section describes the regulation notices. Grounding (Finland; FI, Norway; NO and Sweden; SE only) FI: Laite on liitettävä suojamaadoituskoskettimilla varustettuun pistorasiaan. NO: Apparatet må tilkoples jordet stikkontact. SE: Apparaten skall anslutas till jordat uttag. Translation: The machine must be connected to a grounded power outlet.
Page 13
Regulation notices The button cell(s) should be removed only by skilled service technicians who are acquaint- ed with the removal instructions provided by Océ Button cell specification Button cell location Button cell ca- Containing the following sub- pacity stances (if applicable) Ibase MAINBOARD, MB896 3.0V CR2032 Lithium type...
Page 14
Imaging Equipment (Version 1.2) Energy consumption (all countries) In order to limit energy consumption during times of non-use the Océ PlotWave 350 has a Sleep mode during which the power level is reduced. The value for the Sleep mode is listed in the Product Safety Data Sheet.
Page 15
This product meets the ENERGY STAR® Guidelines for energy efficiency. Recycled paper (all countries) The use of recycled paper benefits the environment. The Océ PlotWave 350 is designed to use recycled paper, which complies with the requirements of EN12281:2002. Product literature on recommended types of recycled copier paper can be obtained from Océ.
You can download the Safety Data Sheets from the support site of your product at http://global.oce.com/support/ Operating environment (all countries) The environmental requirements for correct operation of the machine are as follows: •...
A Knowledge Base (OKB) with answers to your questions or problems is continuously being updated. To find an answer to your question or problem, please visit: http://global.oce.com/support and select your product. In the Support section, use the search field to enter your question. You will get a list of possible answers.
Page 21
Online support for your product Addresses of local Océ organizations For the addresses of local Océ organizations, visit: http://global.oce.com/contact/countries Comments Send your comments by e-mail to: itc-userdoc@oce.com Chapter 4 - Miscellaneous...
Page 22
2012Océ. Illustrations and specifications do not necessarily apply to products and services offered in each local market. Technical specifications are subject to change without prior notice. Trademarks mentioned in this document are the property of their respective owners. For more information visit us at: www.oce.com 2012-01...
Need help?
Do you have a question about the PlotWave 350 and is the answer not in the manual?
Questions and answers