Stamping Function - Oce 3121 Technical & Service Manual

15 Stamping function

Outline
The stamp operates in memory transmission state or direct transmission state.
The stamping operation is initiated in response to a command from the copier.
Solenoid (Sl4) energises, placing a dot of approximately 3 mm in diameter on
the surface of documents.
Mode
Single sided documents
mode
two-sided document mode
Image Composition Mode
The location of the stamp.
Document
Centre of the document
50 mm (approxi-
mately)
Operation
Stamping occurs when the document is stopped during delivery.
The document is stopped, after feeding it about 20 mm from a point where the
sensor (S12) has detected its leading edge. When the document stops, the
RDF control PBA generates the stamp solenoid drive signal (STSLD). The so-
lenoid (SL4) energises. The stamp face, attached to the tip of the plunger of the
solenoid, is brought down onto the surface of the document.
556 TSM Océ 3121
Location of the stamp
Stamps on each document.
Stamps the first document
Stamps on each document.
Feeding direction
50 mm (approximately)
Functional description