Oce 3121 Technical & Service Manual page 159

#003 (trans/recep) Time-out occurred while transmitting or receiving a single-page
document.
Main cause
The document is too long: requiring longer
I
than specified for transmission or scanning.
Reception is taking longer than specified.
I
The internal mechanism has a fault.
I
#005 (trans/recep) Time-out occurred during initial identification (T1).
Main cause
Incorrect tone and pulse setting.
I
The delay for a line connection is too long.
I
The other machine does not respond.
I
The communication mode (e.g., G2, G3) of
I
the other machine is incorrect (mismatch).
The other machine malfunctions: because of
I
an echo during transmission.
The machine malfunctions: because of an
I
echo during reception.
#009 (recep) The recording paper has jammed or run out.
Main cause
The recording paper has jammed.
I
The recording paper has run out.
I
The internal mechanism has a fault.
I
ed.2
Action
Split the document into several pages, and
I
restart.
Increase the setting of the page timer, using
I
bit 0/1 of #1 SSSW/SW12.
Ask the other party to split the document
I
into several pages for transmission.
Increase the setting of the page timer, using
I
bit 0/1 of #1 SSSW/SW12.
Check the electrical connections (e.g., PBA
I
of the feeder; sensors, motors).
Action
Correct the tone and pulse settings, using
I
[TEL LINE TYPE] with user data.
Allow a relatively long pause when register-
I
ing for auto dialling. This delays the timer
start function.
Increase the T1 timer setting, using ' # 3
I
NUMBER-IC ' Param. 10 (service data).
Preventing time-out.
Contact the other party, and enquire about
I
the cause.
No corrective action is available. (Some ma-
I
chines do not offer certain communication
modes.)
Prevent echoes, using #1SSSW SW03: with
I
service data.
Action
Remove the jam.
I
Place copy paper in the cassette.
I
Check the jam sensor.
I
Check the electrical connections (e.g., PBA
I
of the pick-up section; sensors).
Trouble shooting 51